All Day Leakproof Tumbler

CARE INSTRUCTIONS

Wash before first use. Then wash daily to keep your tumbler fresh, your print flawless, and the vacuum seal strong.

CLEANING STEP-BY-STEP

1. Disassemble the lid (gently):

• • Separate the lid from the tumbler.
    
    
  • Pull the straw out of the lid to separate it for easier cleaning.
    
    
  • Turn the lid to the “close” position.
    
    
  • Slightly loosen the small threaded cap at the bottom (don’t unscrew it fully).
    
    
  • Grip the top lid section and twist it left (counterclockwise), away from the “close” icon, then lift it off.
    
    

2. Always wash the tumbler by hand to preserve prints.
   Use warm water, mild soap, and a soft sponge.
   The lid (top + bottom) and straw are dishwasher safe.

3. Rinse well:
   Don’t leave any soap behind. 
   
4. Air dry fully:
   Moisture = odors. Let it breathe before you reassemble.
   
   
5. Reassemble the lid:

• • Align the top lid with the “close” icon on the bottom lid.
    
    
  • Press the pieces together gently, then twist the top right (clockwise) until it sits flush and aligned.
    
    
  • Fasten the threaded cap underneath snugly, ensuring it's secure, but not overtightened.
    
    
  • Put the straw, along with the silicone part, back into its place
    
    

 

DEEP CLEANING (AS NEEDED)

For funky smells or stubborn stains:

• Add a spoonful of baking soda to hot water in the tumbler. Let it sit for 15–20 min.
  
  
• Rinse.
  
  
• For the straw, soak it in the same solution for a deeper clean.
  
  

 

CARE TIPS

Hand wash the printed part only.
Dishwashers can fade the design and mess with the seal. Don’t risk it.

Plastic parts + straw = dishwasher safe.
Just pop them on the top rack.

No rough stuff.
Skip steel wool or scouring pads.

No microwaves. Ever.
There’s metal inside. Don’t test it.